Miele Dryer Error Code F16

• Dryer runs but produces little to no heat
• Clothes remain damp after a complete drying cycle
• Dryer may shut off prematurely
• Extended drying times with reduced warmth
• F16 error code displayed on the control panel
• Dryer drum continues to rotate but without heat generation

• Faulty heating element (240V resistive coil) requiring replacement
• Malfunctioning thermal sensor or thermistor unable to detect temperature changes
• Broken thermal cutoff safety switch that interrupts heating
• Loose or corroded electrical connections at the heating element terminals
• Clogged exhaust vent reducing airflow and triggering safety shutoff
• Defective heating relay on the control board
• Power supply issues affecting 240V heating circuit delivery
• Lint accumulation around heating element area restricting proper function

• Check your home's circuit breaker panel to ensure the 240V breaker serving the dryer is fully engaged and not tripped
• Remove and thoroughly clean the dryer's lint filter before each use
• Inspect the dryer vent hose at the back of the unit and follow it outside to ensure no blockages, kinks, or lint buildup exist
• Remove excess clothing from the drum and avoid overloading the dryer beyond recommended capacity
• Fully close the dryer door and ensure the door latch engages with an audible click
• Turn off the dryer's circuit breaker for 60 seconds, then turn it back on to reset the appliance control system
• Verify the dryer's power cord is fully seated in the wall outlet with no visible damage to the plug or cord
• Clean the exterior vent opening if you have access to ensure unrestricted exhaust airflow