Miele Dishwasher Error Code F15

• Dishwasher stops mid-cycle and displays F15 error code
• Water is not filling into the wash chamber
• Dishes remain unwashed or only partially cleaned
• Error code appears repeatedly on consecutive wash cycles
• Reduced water pressure during fill phase
• Dishwasher makes unusual noises during the fill cycle

• Water inlet valve is blocked or partially closed due to mineral deposits
• Kinked or pinched water supply hose restricting flow
• Household water pressure is below minimum requirement (20 PSI)
• Faulty water inlet valve solenoid
• Clogged water inlet filter screen
• Main water shut-off valve is not fully open
• Frozen water supply line in cold climates
• Issues with 120V electrical connection to water inlet valve
• Defective water level sensor

• Check your home's circuit breaker to ensure power to the dishwasher is active and not tripped
• Inspect the water supply hose behind the dishwasher for kinks, pinches, or damage
• Verify the main water shut-off valve under your sink is fully open
• Locate and check the inlet water shut-off valve (usually under the sink) and ensure it is completely open
• Inspect the inlet hose connection points for leaks or loose fittings
• Check that the dishwasher filter (located in the lower tub) is clean and not clogged
• Ensure the spray arms can rotate freely and are not blocked by dish placement
• Confirm the dishwasher door is fully closed and latched securely
• Test water pressure at your kitchen sink to ensure adequate household water pressure
• Reset the dishwasher by turning off the circuit breaker for 60 seconds, then turning it back on
• Run a test cycle to see if the error code reappears after reset