Miele Dryer Error Code nA

• Refrigerator not cooling properly or maintaining set temperature
• Freezer section warmer than normal
• Error code nA displayed on the control panel
• Compressor running continuously or not running at all
• Food spoiling faster than expected
• Ice maker not producing ice or producing less ice than normal
• Unusual noises from the compressor or refrigerant lines
• Condensation or frost buildup in unusual areas

• Low refrigerant charge due to slow leak in sealed system
• Refrigerant circuit blockage or restriction
• Faulty compressor not pumping refrigerant effectively
• Defective thermal expansion valve or capillary tube
• Pressure sensor malfunction detecting incorrect system pressure
• Loose or disconnected refrigerant line connections
• Failed evaporator or condenser coil
• Control board failure misreading pressure or temperature signals
• 120V electrical supply voltage fluctuation affecting compressor operation

• Check your home circuit breaker panel to ensure the refrigerator circuit breaker is ON and not tripped; reset if necessary
• Verify the refrigerator is plugged in securely and the outlet is functioning by testing with another 120V appliance
• Inspect refrigerator vents inside and outside the unit to ensure air circulation is not blocked by food, ice, or debris
• Confirm both the refrigerator and freezer door seals are clean, undamaged, and closing completely without gaps
• Check that refrigerator temperature settings are appropriate (typically 37-40°F for fridge, 0-5°F for freezer)
• Clean the condenser coils on the back or bottom of the unit using a soft brush to remove dust buildup
• Allow 24 hours after cleaning condenser coils for the system to stabilize
• Perform a soft reset: turn off the refrigerator circuit breaker for exactly 60 seconds, then turn back ON and observe if error clears
• If error persists after these checks, discontinue use and contact Miele customer service or an authorized technician for repair