Miele Refrigerator Error Code F2

• Refrigerator compartment not cooling properly or cooling inconsistently
• Freezer section operating normally while fridge section remains warm
• Error code F2 displayed on the digital control panel
• Compressor running continuously or cycling irregularly
• Food spoiling faster than normal
• Condensation buildup inside refrigerator compartment
• Audible alarm or beeping sounds from the appliance

• Faulty temperature sensor (thermistor) in the refrigerator compartment
• Loose or disconnected wiring harness connected to the temperature sensor
• Defective control board or main PCB unable to read sensor input
• Temperature sensor probe damaged or blocked by ice buildup
• Failed sensor connection point corroded or oxidized
• 120V power supply fluctuations affecting sensor calibration
• Manufacturing defect in sensor component

• Check that the circuit breaker serving the refrigerator hasn't tripped; reset if necessary
• Ensure the refrigerator is plugged in firmly and the outlet is functioning by testing with another appliance
• Verify that condenser coils on the back or bottom of the unit are not blocked by dust; carefully vacuum if accessible
• Confirm both the refrigerator and freezer doors close completely and seal tightly with no gaps
• Check that temperature control settings are not set too high; adjust to recommended 35-38°F for fridge section
• Remove any items blocking air vents inside the refrigerator compartment
• Inspect the back wall of the refrigerator for excessive ice buildup that may be blocking the sensor
• Perform a full appliance reset: turn off the circuit breaker for 60 seconds, then turn back on to allow the control board to reinitialize
• If error persists after these checks, contact a certified Miele technician as the temperature sensor likely requires professional replacement