Miele Dryer Error Code F50

• Dryer runs but produces no heat or significantly reduced heat
• Clothes remain wet or damp after a complete drying cycle
• Error code F50 displays on the control panel
• Drying time extends longer than normal
• Dryer may shut off prematurely during operation

• Faulty heating element unable to generate proper heat at 240V
• Malfunctioning thermal cutout switch that detects overheating
• Failed temperature sensor providing incorrect readings to control board
• Broken or disconnected wiring harness to heating assembly
• Buildup of lint or debris on heating element affecting performance
• Defective control board unable to send proper voltage to heating circuit
• Failed thermistor or thermal sensor in the exhaust duct

• Check that the dryer is properly plugged in and the circuit breaker is switched ON
• Verify the 240V outlet is functioning by testing with another appliance if safe to do so
• Remove and thoroughly clean the lint trap after each load
• Inspect the external vent hood to ensure it opens freely and is not blocked by lint or debris
• Check the dryer vent duct for blockages or kinks that restrict airflow
• Ensure you are not overloading the dryer drum—fill it only three-quarters full
• Verify the dryer door closes completely and latches securely
• Perform a hard reset: Turn off the circuit breaker for 60 seconds, then turn it back ON
• Allow the dryer to cool for 15-20 minutes before restarting if it shut off suddenly