Miele Oven & Range Error Code FE44

• Oven will not heat or maintains incorrect temperatures
• Display shows FE44 error code
• Heating elements do not activate
• Unable to set or maintain desired cooking temperature
• Oven may stop mid-cycle
• Range/convection fan may not operate properly
• Self-cleaning function unavailable

• Faulty temperature sensor (RTD probe) in the oven cavity
• Damaged or loose wiring connections between sensor and control board
• Control board malfunction preventing sensor signal recognition
• Temperature sensor connector disconnected or corroded
• Broken or short-circuited sensor element from thermal stress
• Electrical interference or voltage fluctuations affecting 240V circuit
• Defective control panel circuit board
• Water or moisture damage to sensor connections

• Turn off power to the oven by switching off the dedicated circuit breaker for 60 seconds, then switch back on to reset the system
• Verify the oven door is fully closed and latches are secure
• Check that the dedicated 240V circuit breaker has not tripped; reset if necessary
• Ensure proper ventilation around the appliance (at least 4-6 inches clearance on sides and back)
• Allow the oven to cool completely for 15-20 minutes before attempting to use it again
• Verify control panel settings are correctly configured and no buttons are stuck
• Disconnect and reconnect the oven's power cord or check if plug is fully seated
• Check for any visible damage to the oven cavity or sensor area (do not touch components)
• Ensure proper 240V voltage is supplied to the appliance using a multimeter if available
• If error persists after these steps, contact a certified Miele service technician for professional diagnosis and sensor replacement