Miele Coffee System Error Code F226

• Machine fails to start brewing cycle when button is pressed
• No water flows through the brew group despite water tank being filled
• Error code F226 displays on the machine's control panel
• Machine shuts down mid-brew cycle
• Weak or no coffee output despite normal operation attempts
• Machine makes unusual grinding sounds without water dispensing

• Water tank is not properly seated or inserted into the machine
• Water inlet valve is clogged or blocked by mineral deposits from hard tap water
• Low water pressure in household water line affecting 120V pump performance
• Brew unit is incorrectly positioned or not fully engaged
• Internal water distribution tubes contain air pockets or blockages
• Descaling is overdue, causing mineral buildup in water pathways
• Faulty water level sensor unable to detect sufficient water
• Damaged or disconnected water line connection inside the machine

• Turn off the machine and unplug it from the 120V outlet for 60 seconds, then plug back in and power on to reset
• Verify the water tank is completely filled with fresh, cold water and firmly clicked into its housing until fully seated
• Remove the water tank, rinse it thoroughly under running water, and inspect for any debris or blockages before reinserting
• Check that the brew unit (portafilter area) is properly aligned and fully locked into position
• Empty and clean the drip tray to ensure no water backup is occurring
• Inspect the bean container for any blockages or jams that could affect water system pressure
• Run the descaling cycle using Miele-approved descaling solution to remove mineral deposits from internal water pathways
• Check that the water inlet at the back of the machine is not kinked or blocked
• Ensure your household water pressure is adequate by testing another faucet in the home